JWX-30 Milling Machine Specifications
| Cuttable Material |
Modeling wax |
| X, Y, and Z Operation Strokes |
X, Y, and Z: 305 x 205 x 100 mm (12 x 8.1 x 3.9 in.)
|
| Connectivity |
USB (compliant with Universal Serial Bus Specification Revision 1.1) |
| |
| POWER REQUIREMENTS |
| Voltage and Frequency |
AC 100 to 120 V/220 to 240 V ±10%, 50/60 Hz (overvoltage category II, IEC
60664-1) |
| Required Power Capacity |
2.8 A (100 to 120 V)/1.2 A (220 to 240 V) |
| Power Consumption |
275 W |
| |
|
| Dimensions |
Height x width x depth: 606 x 656 x 557 mm (23.9 x 25.9 x 22 in.) |
| Weight |
47 kg (104 lb) |
| Environmental |
Operating environment: Temperature of 5 to 40°C (41 to 104 °F), 35 to 80% relative
humidity (no condensation) Ambient pollution degree: 3 (as specified by IEC 60664-1) |
| Accessories |
Power cord, Handy panel, Tools for modeling (ball end mill, diameter 3.175mm /conical
end mill, diameter 3.175 mm), collet (diameter 3.175 mm), detection pin, hexagonal screwdriver,
hexagonal wrench, cap screws (10), spanner (10 mm, 17mm), modeling wax, clamp holder, square clamp
(large), square clamp (small), swivel clamp, tube clamp, dust tray, blower fan, User’s Manual (this
document), SRP Player Installation and Setup Guide, SRP Player CD-ROM, Roland Software Package CD-ROM,
Roland JewelStudio DVD-ROM |
| |
| SYSTEM REQUIREMENTS |
| Computer |
| Model preinstalled with Windows Vista, XP, 2000, or upgraded computer originally
preinstalled with Windows 2000 or later |
|
| Pentium, Celeron, or higher processor |
|
| 1 GB disk space |
|
| 512 MB RAM (1 GB or more recommended) |
|
| OpenGL graphic card recommended |
|
| IntelliMouse recommended |
|
| USB cable |
Use a shielded cable up to three meters (10 ft.) in length |
|